Инструкция на S45-2 (English)Страница 8 из 17
• When approaching the lift with a vehicle, center the vehicle between the columns so that the tireswill clear the swing arms easily. Slowly drive the vehicle up between the posts. Have some one outside the vehicle guide the driver. • Always lift vehicle using all four pads. • Never use lift to raise one end or one side of vehicle. • Raise vehicles about 3” and check stability by rocking. • Prior to lowering vehicle, walk around the lift and check for any objects that might interfere with the operation of lift and safety latches; tools, air out. Have some one outside the vehicle guide the driver. The following periodic maintenance is the suggested minimum requirements and minimum intervals; accumulated hours or monthly period, which ever comes sooner. If you hear a noise not associated with normal lift operation, or, if there is any indication of impending lift failure -CEASE OPERATION IMMEDIATELY ! - inspect, correct and /or replace parts as required. WARNING: OSHA AND ANSI REQUIRE TO INSPECT LIFTING EQUIPMENT AT THE START OF EVERY SHIFT. THESE AND OTHER PERIODIC INSPECTIONS ARE THE RESPONSIBILITY OF THE USER. DAILY PRE-OPERATION CHECK (8 HOURS) The user should perform daily check. ATTENTION ! Daily check of safety latch system is very important - the discovery of a potential device failure could prevent expensive property damage, lost production time, serious personal injury, and even death. • Check safety lock audibly and visually while in operation • Check safety latches for free movement and full engagement with rack. • Check hydraulic connections, and hoses for leakage. • Check chain connections - bends , cracks - and loose links. • Check cables connections - bends , cracks - and looseness. • Check for frayed cables in both raised and lowered position. • Check snap rings at all rollers and sheaves. • Check bolts, nuts, and screws and tighten if needed. • Check wiring &switches for damage. • Keep base plate free of dirt, grease or any other corrosive substances. • Check floor for stress cracks near anchor bolts. • Check swing arm restraints. • Check anchor bolts torque to 150 ft - Ibs the 3/4” anchor bolts. |
