Инструкция на 2-Post Lifts S4B-2/T4 (англ.)

anchor, ³/4”. (.775 to .787 inches diameter). Do not use excessively worn bits or bits

which have been incorrectly sharpened.

2. Keep the drill in a perpendicular line while drilling.

3. Let the drill do the work. Do not apply excessive pressure. Lift the drill up and down occasionally to remove residue to reduce binding.

4. Drill the hole to depth equal to the length of anchor.

5. For better holding power blow dust from the hole.

6. Place a flat washer and hex nut over threaded end of anchor, leaving approximately V2 inch of thread exposed carefully tap anchor. Do not damage threads. Tap anchor into the concrete until nut and flat washer are against base plate. Do not use an impact wrench to tighten. Tighten the nut, two or three turns on average concrete (28-day cure). If the concrete is very hard only one or two turns may be required.

INSTALLATION INSTRUCTION FOR S4B-2 AND T4 2-COLUMN HYDRAULIC LIFTS

MODEL: S4B-2 and T4

PLEASE READ THIS INSTRUCTION BEFORE STARTING TO OPERATE THE LIFT.

STEP 1: After unloading the lift, place it near the intended installation location.

STEP 2: Remove the shipping bands and packing materials from the unit.

STEP 3: Remove the packing brackets and bolts holding the two columns together (do not discard

bolts, they are used in the assembly of the lift)

STEP 4: Once the power unit column location is decided, insure that the proper lift placement is

observed from walls and obstacles. Also check the ceiling height for clearance in this location. Note the power unit column can be located on either side. It is helpful to try and locate the power side with the passenger side of the vehicle when loaded on the lift to save steps during operation.

STEP 5: Assemble the uprights to the columns on model S4B-2, (T4 has columns only-no uprights). Raise the columns to a vertical position. (See Fig. 6).

STEP 6: Position the columns facing each other 134" outside base plates.

Страницы: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31