Инструкция на 2-Post Lifts S4B-2/T4 (англ.)Страница 4 из 31
The installation of this lift is relatively simple and can be accomplished by 2 men in a few hours. The following tools and equipment are needed: AW 32, 46 or other good grade Non-Detergent Hydraulic Oil SAE-10 (12 quarts) Chalk line and 12' Tape Measure Rotary Hammer Drill with 3/4" Drill Bit. Core Drill Rebar Cutter recommended Transit and a 4' Level Sockets and Open Wrench set, 1/2" thru 1-1/2"(1-1/8"for 3/4" Anchors) Vise Grips 1. Identify the components and check for shortages. If shortages are discovered, contact us immediately. Save the shipping bolts for use in the installation. 2. Lift location - check with building owner and/or architect's building plans when applicable. The lift should be located on a relatively level floor with 4" 3000 psi concrete sufficiently cured with no cracks within 36" and no seams with in 6"of the base plate. Remember any structure is only as strong as the foundation on which it is located. Check for ceiling clearance -(lifting height plus vehicle height if installing the T4). Check for clearance in the front and rear of vehicle when on lift - will the garage door open.
Please also read the general information about this lift shown of Fig 1 for T4 Floor Plate type, Fig 2 for S4B-2 Clear Floor type and Fig 4 for Symmetric type and Fig 5 for Asymmetric type. Страницы: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 |
