Документация

Инструкция на TECO 91-93 (англ.)

Страница 34 из 39

The machine fails to switch on but the master switch indicator lamp is lit

One of the fuses on the circuit board is blown (FI, F2 or F3)

^ Renew the fuse

The machine is on, but when the levers are operated the wheel do not move (only Teco 93)

Failure of supply to pneumatic system

^ Check that there is air in the pneumatic circuit, and that the pressure is correct.

Motor breakdown ^ Call TECO technical service.

Microswitch incorrectly positioned

^ Call TECO technical service.

The balancing machine gives non-repetitive unbalance data

The machine was jolted during a spin

^ Repeat the spin taking care not to jolt the machine during data reading The machine is not resting stably on the floor

^ Check that the machine is located stably and shim to level it if necessary The wheel is not clamped properly

^ Tighten the spinner properly

^ Verify that the accessories used for the centering are suitable.

Multiple spins are needed to balance a wheel

The machine was jolted during a spin

^ Repeat the spin taking care not to jolt the machine during data reading The machine is not resting stably on the floor

^ Check that the machine is located stably and shim to level it if necessary The wheel is not clamped properly

^ Tighten the spinner properly

^ Verify that the accessories used for the centering are suitable The wheel data input are incorrect

^ Enter the correct wheel data

The machine is out of calibration

^ Perform the calibration procedure

0 WARNING

The "Spare parts” handbook does not authorise the user to carry out work on the machine with the exception of those operations explicitly described in the user's manual, but enables the user to provide the technical assistance service with precise information, in order to reduce delay.

MAINTENANCE

The manufacturer declines all liability for claims deriving from the use of non-original spares or accessories.

Before making any adjustments or performing maintenance, disconnect the electrical supply from the machine and make sure that all moving parts are suitable immobilised.

Do not remove or modify any parts of this machine except in the case of service interventions.

Страницы: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Пароль
Вход забыли пароль? Регистрация

Платные услуги