Инструкция на TT-5.5F4 (новый, англ.)Страница 19 из 30
OPERATION Only trained person can operate and check as follows: -clear obstacles around before operation. -during lifting or lowering, no person is allowed to stand near the two sides and beneath the machine, and no person is allowed on the two platform. -avoid lifting super heavy vehicles or other thing. -when lifting vehicle, the hand brake lever of the vehicle should be pulled, and the slide resistant triangle woods should be used. -pay attention to the synchronization of the lifting and lowering. If any thing abnormal is found, stop the machine timely, check and remove the trouble. -when locking the main machine, the two platforms should be kept at the same height. -when the equipment has not used for a long time or over night, the machine should be lowered to the lowest position on ground, and remove vehicle, and cut off power supply. Instructions on electric operation :( see the operation panel) Lift the main machine: -if equipped with electrical carriage, first turn the manual selector on “main machine” position. -press “up” button SB1, oil pump working, and the platform lift. -unfasten SB1, oil pump stop working, and immediately stop lifting. Main machine lower -press “down” button SB2, and then press safety manual hand, lower the platform. Unfasten manual hand, stop lower. -if the insurance is there, lift the platform, and then press “down” Main machine locking -single press “lower”, platform lower. Emergency stop -press “emergency stop” button SB0 and locking, cut off all the operation circuit when machine is abnormal. Страницы: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 |
