Инструкция на TT-5.5F4 (новый, англ.)Страница 14 из 30
CROSSBEAM INSTALLATION -fix the front and back crossbeam on the floor. -Put a wood or an iron under the crossbeam in order to raise 100-300mm. -fix eight nylon anti-crashes inner and outer of the crossbeam. BEAM INSTALLATION: -Put two beam on the transom, the main beam should located on the left side of the moving vehicle direction, the sub-beam located on the right side, the rolling wheel notch on the beam should inside. -check two platform and the diagonal of two transom are straight, then put four posts on the side of the transom, and fix the nuts on the roof of the post with steel line, put the safety teeth trough the limit axis, also fix the nuts on the roof of the post. POST INSTALLATION: Unload the spoon under the insurance in the post. ROLLING JACK INSTALLATION (optional add): -adjust the distance of the rolling jack; put the rolling jack between the slide track. -adjust the sub beam to make sure the sliding of the rolling jack. ROLLING JACK INSTALLATION -adjust the distance of the rolling jack; put the rolling jack between the slide track. -adjust the sub beam to make sure the sliding of the rolling jack. LINE CONNECTION Connect the electrical and oil line according to the electric wiring diagram and oil line connection To avoid the unexpected lift closure due to mechanical safety device release insert wooden pieces in the inner part of the base frame. Pay attention not to work under the lift until the hydraulic system has not been completely filled with hydraulic oil. Страницы: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 |
